Accessori per strumenti di sviluppo (241 articoli)

Adattatore J-Link RX. L' adattatore J-Link RX converte il connettore J-Link a 20 pin da 0,1 ;quot; nel connettore Renesas a 14 pin da 0,1 ;quot; e consente i collegamenti JTAG + FINE ai dispositivi...

Adattatore Cortex-M a 9 pin J-Link. L' adattatore Cortex-M a 9 pin J-Link consente i collegamenti JTAG, SWD e SWO tra J-Link e sistemi hardware target basati su ARM Cortex-M. Sonde supportate. J-Li...

The SEGGER J-Link 14-Pin TI Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch Texas Instruments connector.Includes a 14-pin TI cable

Adattatore ad ago a 10 pin J-Link. L' adattatore ad ago a 10 pin J-Link è stato progettato per collegare una sonda J-Link a un circuito stampato non dotato di un connettore di accoppiamento o conne...

The SEGGER J-Link TI-CTI-20 Adapter has been designed to connect from the standard J-Link/J-Trace/Flasher 20-pin 0.1″ target connector to TI CTI-20 connector.Adapter permits the connection of the J...

The SEGGER Adapter for PPC targets with 14-pin 0.1″ mating JTAG connectors.Includes a 14-pin ribbon cable

The SEGGER J-Link Mictor 38 Adapter connects the standard 20-pin 0.1″ J-Link interface to the 38-pin Mictor interface. The pinout follows the single target connector pinout specification as defined...

The SEGGER J-Link RX FINE Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch RX FINE connector. Includes the necessary cable.Package includes: .1″ 14-pin ribbon cable (1...

The SEGGER J-Link 2mm Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 20-pin, 2mm pitch connector.The J-Link 2mm Adapter is a 1:1 adapter

The SEGGER J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Depending on target load capacitance, signals mig...

The SEGGER J-Link Measurement+Patch Adapter provides test points for all debug signals to allow easy access for test probes. It has a standard 20-pin 0.1″ socket towards the J-Link debug probe and ...

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

The SEGGER J-Link 6-pin Needle Adapter has been designed to connect J-Link to a PCB which does not come with a mating connector or programming header.No additional connector required on your PCB Ve...

The SEGGER J-Link SiLabs C2 Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 10-pin, 0.1 inch pitch SiLabs C2 connector.Includes 10 pin ribbon cable

Adattatore di alimentazione target J-Link. L' adattatore di alimentazione target J-Link fornisce un alimentatore regolabile per una scheda target. Sonde compatibili. Emulatore Segger J-Link BASE ( ...