Accessori per strumenti di sviluppo (25 articoli)

Adattatore Cortex-M a 9 pin J-Link. L' adattatore Cortex-M a 9 pin J-Link consente i collegamenti JTAG, SWD e SWO tra J-Link e sistemi hardware target basati su ARM Cortex-M. Sonde supportate. • J-...

Adattatore Cortex-M a 19 pin J-Link. L' adattatore Cortex-M a 19 pin J-Link consente i collegamenti JTAG, SWD e SWO tra J-Link e sistemi hardware target basati su ARM Cortex-M. Sonde supportate. • ...

The SEGGER J-Link 14-Pin TI Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch Texas Instruments connector.Includes a 14-pin TI cable

The SEGGER J-Link Microchip 2-Wire JTAG TDI Adapter allows debug connections between J-Link and target hardware which comes with Microchip IS208x series MCUs. It supports the Microchip 6-pin single...

The SEGGER J-Link 2mm Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 20-pin, 2mm pitch connector.The J-Link 2mm Adapter is a 1:1 adapter

The SEGGER SiFive-ARTY Adapter allows debug connections between J-Link and the ARTY board running SiFive RISC-V core bitstreams.The ARTY board provides several identical headers where the JD header...

The SEGGER J-Link RX FINE Adapter converts the 20-pin, 0.1 inch standard connector to a 14-pin, 0.1 inch RX FINE connector. Includes the necessary cable.Package includes: .1″ 14-pin ribbon cable (1...

The SEGGER J-Link Signal Smoothing Adapter can be inserted between the J-Link debug probe and the debug target to overcome signal integrity issues. Depending on target load capacitance, signals mig...

Ladattatore Flasher RL78 converte il connettore J-Link standard a 20 pin da 0,1″ nel connettore E1 a 14 pin definito da Renesas. Si noti che ladattatore è utilizzabile solo con i modelli Flasher PR...

The SEGGER Flasher STM8 Adapter converts the standard J-Link 20-pin 0.1″ connector to the SWIM connector and a standard 10-pin connector. In addition the target board can be power using the externa...

The SEGGER Adapter for PPC targets with 14-pin 0.1″ mating JTAG connectors.Includes a 14-pin ribbon cable

The SEGGER Adapts from the standard J-Link 20-pin 0.1″ target connector to Xilinx 14-pin 2 mm connector (comp. Platform Cable USB II).Package includes: 14-pin 2mm ribbon cable

The SEGGER Intel FPGA Adapter (formerly J-Link Altera Adapter) connects to the 10-pin 100-mil Intel FPGA JTAG connector providing debug access to FPGA based MCU cores like the dual-core ARM Cortex-...

The SEGGER J-Link SiLabs C2 Adapter converts the 20-pin, 0.1 inch pitch standard J-Link connector to a 10-pin, 0.1 inch pitch SiLabs C2 connector.Includes 10 pin ribbon cable

Adattatore a 14 pin ARM7/9/11 J-Link. L' adattatore a 14 pin J-Link consente il funzionamento di J-Link con i processori target ARM7/9/11. Non è necessario con la maggior parte delle nuove schede d...